Witam!
Posiadam kamerę SAMSUNG VP-D103.
Kompletnie nie mam pojęcia jak obsłużyć tą kamerę pod Linuksem i z jakiego oprogramowania skorzystać. Film na kamerze nagrany jest na taśmę magnetyczną.
Do tego log po podłączeniu kamery:
[churajia@mind ~]$ dmesg | tail -n 20
b44: eth0: Flow control is off for TX and off for RX.
b44: eth0: Link is down.
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
[drm] Setting GART location based on new memory map
[drm] Loading R300 Microcode
[drm] writeback test succeeded in 1 usecs
b44: eth0: Link is down.
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
b44: eth0: Link is down.
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
b44: eth0: Link is down.
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
usb 1-2: USB disconnect, address 3
usb 1-2: new full speed USB device using uhci_hcd and address 4
usb 1-2: config 1 interface 0 altsetting 0 has 3 endpoint descriptors, different from the interface descriptor's value: 2
usb 1-2: configuration #1 chosen from 1 choice
[churajia@mind ~]$
Dobrze by było gdyby oprogramowanie było napisane w GTK+, ale nie jest to obowiązkowe.