Witam.
W moim starym laptopie podejrzewam, że dysk się psuje. Laptop ma 5 lat. Ostatnio zawiesił się, gdy go zrestartowałam, to tylko czarny ekran i “No bootable partition in table”. Ok myślę wina Windowsa. Skopiowałam dane, wczyściłam dysk, zrobiłam w końcu partycje jak chciała w gparterze, zainstalowałam linuxa. Chwile podziałał i za chwile to samo co z windowsem “no bootable…”. Od razu mówię, że tu nie chodzi o Grub itp, za drugim razem tylko linuxa miałam, windowsa nie zdążyłam zainstalować, a grub umiem przywracać.
Wcześniej jeszcze zniknął mi cały folder Desktop z windowsa, ale nie jestem pewna czy to nie wina wirusów, bo dawno kompa wtedy nie czyściłam.
To zainstalowałam linuxa jeszcze raz i teraz (pewnie chwile, chociaż nie wiem) działa.
Wrzucam log z programu. Ktoś mógłby mi coś powiedzieć co z tym dyskiem?
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.8.0-29-generic] (local build)
Copyright © 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.6
Device Model: ST9250315AS
Serial Number: 5VC6H1ZV
LU WWN Device Id: 5 000c50 0191319b7
Firmware Version: 0001SDM1
User Capacity: 250,059,350,016 bytes [250 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Thu Jan 23 10:41:23 2014 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSEDGeneral SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 70) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail Always - 161220663
3 Spin_Up_Time 0x0003 099 099 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 094 094 020 Old_age Always - 6285
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 18
7 Seek_Error_Rate 0x000f 083 060 030 Pre-fail Always - 4512455935
9 Power_On_Hours 0x0032 098 093 000 Old_age Always - 1981
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 094 037 020 Old_age Always - 6256
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 072 072 000 Old_age Always - 28
188 Command_Timeout 0x0032 100 096 000 Old_age Always - 4762
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 065 055 045 Old_age Always - 35 (Min/Max 22/35)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 383
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 8
193 Load_Cycle_Count 0x0032 050 050 000 Old_age Always - 101543
194 Temperature_Celsius 0x0022 035 045 000 Old_age Always - 35 (0 15 0 0)
195 Hardware_ECC_Recovered 0x001a 053 042 000 Old_age Always - 161220663
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0SMART Error Log Version: 1
ATA Error Count: 25 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It “wraps” after 49.710 days.Error 25 occurred at disk power-on lifetime: 1381 hours (57 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.After command completion occurred, registers were:
ER ST SC SN CL CH DH
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
60 00 80 ff ff ff 4f 00 01:12:39.774 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 01:12:39.769 READ FPDMA QUEUED
60 00 80 ff ff ff 4f 00 01:12:39.767 READ FPDMA QUEUED
60 00 80 ff ff ff 4f 00 01:12:39.765 READ FPDMA QUEUED
61 00 00 10 20 30 42 00 01:12:39.763 WRITE FPDMA QUEUEDError 24 occurred at disk power-on lifetime: 1310 hours (54 days + 14 hours)
When the command that caused the error occurred, the device was active or idle.After command completion occurred, registers were:
ER ST SC SN CL CH DH
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
60 00 80 ff ff ff 4f 00 00:07:42.123 READ FPDMA QUEUED
61 00 08 f0 ec 46 42 00 00:07:42.122 WRITE FPDMA QUEUED
61 00 18 d8 e7 46 42 00 00:07:42.122 WRITE FPDMA QUEUED
61 00 08 60 d5 46 42 00 00:07:42.122 WRITE FPDMA QUEUED
61 00 08 b8 a0 46 42 00 00:07:42.121 WRITE FPDMA QUEUEDError 23 occurred at disk power-on lifetime: 1310 hours (54 days + 14 hours)
When the command that caused the error occurred, the device was active or idle.After command completion occurred, registers were:
ER ST SC SN CL CH DH
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
61 00 08 d0 1b ff 41 00 00:07:39.406 WRITE FPDMA QUEUED
60 00 80 ff ff ff 4f 00 00:07:39.405 READ FPDMA QUEUED
61 00 10 e8 8a ff 41 00 00:07:39.404 WRITE FPDMA QUEUED
2f 00 01 10 00 00 40 00 00:07:39.249 READ LOG EXT
61 00 08 20 35 d4 42 00 00:07:36.911 WRITE FPDMA QUEUEDError 22 occurred at disk power-on lifetime: 1310 hours (54 days + 14 hours)
When the command that caused the error occurred, the device was active or idle.After command completion occurred, registers were:
ER ST SC SN CL CH DH
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
61 00 08 d8 1b ff 41 00 00:07:34.178 WRITE FPDMA QUEUED
61 00 01 b0 a0 46 42 00 00:07:34.178 WRITE FPDMA QUEUED
61 00 10 a8 8a ff 41 00 00:07:34.177 WRITE FPDMA QUEUED
60 00 80 ff ff ff 4f 00 00:07:34.176 READ FPDMA QUEUED
61 00 01 40 aa a4 41 00 00:07:34.175 WRITE FPDMA QUEUEDError 21 occurred at disk power-on lifetime: 1310 hours (54 days + 14 hours)
When the command that caused the error occurred, the device was active or idle.After command completion occurred, registers were:
ER ST SC SN CL CH DH
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
61 00 08 d0 1b ff 41 00 00:07:31.126 WRITE FPDMA QUEUED
60 00 80 ff ff ff 4f 00 00:07:31.124 READ FPDMA QUEUED
61 00 18 90 8a ff 41 00 00:07:31.124 WRITE FPDMA QUEUED
61 00 09 b0 f2 07 45 00 00:07:31.123 WRITE FPDMA QUEUED
61 00 05 b0 c5 d2 44 00 00:07:31.122 WRITE FPDMA QUEUEDSMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error1 Short offline Completed without error 00% 1981 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.